C.A. Technologies AutoCAT 300C

Inside This Document

The setup and parts sheet for the C.A. Technologies AutoCAT 300C — the conventional-atomization version of CAT's 300-series automatic spray gun. The air cap and fluid nozzle chart pairs the 23-2013/23-2014/23-2016 caps with fluid nozzles from 0.8 mm (33-0608) to 1.6 mm and matching 40-A3xx needles, with suggested gun inlet pressures and SCFM figures. Mounting (left, right, or bottom via the included rod), operation, and the full parts breakdown complete the 5 pages.

From the Document

CONVENTIONAL AIR CAP AND FLUID NOZZLE CHART MODEL NO. AIR CAPS Press / Siphon *SUGGESTED GUN INLET PRESS. FAN CONTROL ORIFICE SCFM AIR CAP RING AVAILABLE FLUID NOZZLES NEEDLES / marking on needle 33-0608 0.8mm (.022") 40-A308 (308) 33-0610 1.0mm (.040") 40-A310 (310) 23-2013* p/s 45-55 9-10.7 33-0613 1.3mm (.052") 40-A313 (313) 23-2014* p/s 45-55 9-10.7 33-0614 1.4mm (.055") 40-A314 (314) 23-2016* p/s 45-55 9-10.7 33-0616 1.6mm (.063") 40-A315 (315) Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Gun inlet pressures may vary as required by application 23-0201 A300C 23-2010* p/s 45-55 None 9-10.7 AUTOMATIC SPRAY GUN PRODUCT INFORMATION A A A A Aut ut ut ut utoC oC oC oC oCA A A A AT 300C T 300C T 300C T 300C T 300C DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for A300C A300C A300C A300C A300C Spray Guns Gun Mounting A 1/2” dia. x 5” lg. rod is provided for mounting. The gun can be mounted from the left or right side or from the bottom. Thread the mounting rod (9) into one of the three holes that best suit the mounting location for the application. Tighten the locknut (10) to secure the gun in the position desired. Do not plug the remaining holes as they are used as drain holes in the event of a needle seal leak. Operation: Connections and Adjustments The automatic gun requires two separate regulated air supply lines. 1. Connect one air line to the fitting marked “CYL”, this actuates the gun on and off and is usually connected through…