C.A. Technologies AutoCAT 100H

Inside This Document

The setup and parts sheet for the C.A. Technologies AutoCAT 100H automatic spray gun in HVLP configuration. The chart maps each air cap model (21-1090, 21-1091, 21-1092 series) to its maximum gun inlet pressure for HVLP compliance (15 PSI class), SCFM consumption, and available fluid nozzles from 0.5 mm up — pairing tips (31-0205, 31-0208, 31-0210) with their matching needles. The reference for setting up compliant automatic HVLP spraying on the AutoCAT platform.

From the Document

HVLP AIR CAP AND FLUID NOZZLE CHART MODEL NO. AIR CAPS Press / Siphon *MAX GUN INLET PRESS. FOR HVLP FAN CONTROL ORIFICE SCFM @ MAX GUN INLET AIR CAP RING AVAILABLE FLUID NOZZLES TIPS NEEDLES / marking on needle 21-1090 pressure 15 6 31-0205 0.5mm (.020") 21-1091 pressure 15 8 31-0208 0.8mm (.022") 21-1092 pressure 15 8 31-0210 1.0mm (.040") 21-1093 pressure 18 10 31-0212 1.2mm (.046") 21-1094 pressure 33 13 31-0213 1.3mm (.052") 21-1095 pressure 50 22.5 31-0214 1.4mm (.055") 21-1097 pressure 50 22.5 31-0215 1.5mm (.059") 21-1195 pressure 50 22.5 31-0216 1.6mm (.063") 21-1197 pressure 50 22.5 31-0217 1.7mm (.070") 31-0412 1.2Fmm (.046") 40-A112F (112F) 31-0414 1.4Fmm (.055") 40-A114F (114F) 31-0417 1.7Fmm (.070") 40-A117F (117F) *Note: Air cap test gages are available to confirm HVLP compliance. Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Gun inlet pressures may vary as required by application 40-A100 (100) A100H 60-616 21-1001 included AUTOMATIC SPRAY GUN PRODUCT INFORMATION A A A A Aut ut ut ut utoC oC oC oC oCA A A A AT 1 T 1 T 1 T 1 T 100H 00H 00H 00H 00H DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for A100H A100H A100H A100H A100H Spray Guns Gun Mounting A 1/2” dia. x 5” lg. rod is provided for mounting. The gun can be mounted from the left or right side or from the bottom. Thread the mounting rod (9) into one of the three holes that best suit the mounting location for the application. Tighten the locknut (10) to secure the…