Binks MAG-II Automatic Air-Assisted

Inside This Document

Part sheet 77-2949 for the Binks MAG II automatic manifold-mounted air-assisted airless HVLP spray gun. Material is forced through a carbide tip at airless pressure, then shaped with assist air for fine-finish HVLP results on automatic lines. The 36 pages cover operation and preventive maintenance across the gun configurations (0511-0HF0, 0511-0HT0, 0511-MHF0, 0511-MHT0 — fan and tip variants with and without manifold), with the parts breakdown to keep MAG II guns in production.

From the Document

The following instructions provide the necessary information for the proper operation and preventive maintenance of the Binks MAG II Automatic Manifold Mounted Air-Assisted Airless HVLP Spray Gun. Please read and understand all information in this document in order to get the maximum performance from your new MAG II spray gun. In the MAG II Automatic HVLP spray gun, the paint or other material to be sprayed is atomized; forced through the carbide tip by the typical 1,500-3,800 psi fluid pressure (with capabilities up to 4,000 psi/275 bar). This atomizing, plus the final shaping air supplied by the air cap, produces an exceptionally fine and even spray pattern. The result of this spray pattern is an even finish that lends itself to products that need an exceptionally fine finish with reduced overspray and VOC emissions. The MAG II Automatic HVLP spray gun uses high pressure to spray paints and solvents. Since liquids sprayed at high pressure can cause injuries, and some paints and solvents can be toxic or cause explosions and fires under certain conditions, your safety and the safety of others depend on your reading the information on this Part Sheet. If you have any questions or do not understand the information presented, call your nearest service representative. NOTE Please be sure to read the warnings on page 2. SPECIFICATIONS: Max. Air Pressure: 100 psi/6.8 bar Twist Tip HVLP: 20 psi inlet pressure is 10 psi air cap pressure @ 5 CFM air volume Flat Tip HVLP: 15 psi inlet pressure is 10 psi air cap pressure @ 8 CFM air volume Max. Fluid Pressure: 4000 psi/275 bar…