Sagola 3300 GTO Black Racing Manual

Inside This Document

Instruction manual for the 3300 GTO Black Racing — the blacked-out limited edition of Sagola's gasket-free GTO platform. Same M2M metal-to-metal construction and individually replaceable parts as the standard 3300 GTO, documented here with setup, adjustment, maintenance, and the full parts diagram.

From the Document

Should there be any doubt relating to the purity of the product, its composition, etc., please contact your supplier. Useful tips 6.1.- General advice You are recommended to use the gun with the product regulator open (without removing it completely from its housing) in order to minimise wear to the fluid tip and needle and to ensure maximum amplitude. Use the lowest spray pressure in the nozzle that allows you to obtain the required finish. Not all products require the maximum pressure for correct spraying. With a lower pressure, less air is consumed and there is an additional increase in product transfer. The gun leaves the factory ready to spray products correctly with the air nozzle corresponding to each application. It is adjusted to an air inlet pressure of 2 bar to ensure maximum performance. The thickness of the film deposited may be greater than planned if the application speed is low, and the opposite is also true.. If the thickness of the layer is very thin , this is due to the fact that the air pressure is excessive for the amount of product being applied. Reduce the air