DeVilbiss JGA Pressure HVLP

Inside This Document

Part sheet SB-2-187-K for the DeVilbiss JGA-510-98FX pressure feed HVLP spray gun. The full-size JGA body carries the low-CFM #98 HVLP air cap, spraying low-to-medium-solids materials at fluid flows in the 7–10 oz/min range while consuming roughly 11 SCFM at the compliant 10 psi cap pressure. The 8 pages cover setup, operation per NFPA-33 practice, and service, with major repair kit KK-4987-2 and minor kit KK-5034 identified for rebuilds of this classic pressure-feed platform.

From the Document

SB-2-187-K (9/2017) 1 / 8 www.carlisleft.com JGA-510-98FX PRESSURE FEED HIGH VOLUME LOW PRESSURE SPRAY GUN Major Repair Kit KK-4987-2 Minor Repair Kit KK-5034 MODEL NUMBER JGA-510-98FX Full Size Gun Body DESCRIPTION The JGA-HVLP pressure feed gun incorporates a LOW CFM HVLP air cap (#98) which is capable of spraying a wide variety of materials (low to medium solids), at fluid flows typically in the 7 to 10 ounce/minute range. Air consumption for the #98 air cap is ap - proximately 11 SCFM @ 10 psi cap pressure. Inlet air pressure of approximately 30 psi (measured at gun handle, flowing ) is required to achieve 10 psi cap pressure. The actual air cap pressure can be verified by using an air cap test kit (see Accessories , page 6). The gun model also includes a conver-sion air baffle, which converts the higher incoming pressure to low pressure (HVLP). All other components, with the exception of the air cap and baffle, are identical to other conventional air spray JGA-510 models. This gun model includes 300 series stainless steel needles and 400 series fluid tips. See IMPORTANT: Before using this equipment, read all safety precau - tions and instructions. Keep for future use. xxx-xxx Body Stamped JGA-510 Air Cap Stamped 98 HVLP Baffle Stamped Max. 30 PSI, 98 page 3 for the 300 series tip and needle which may be ordered separately. This gun can be used with chlorinated solvent materials, but see page 2 for additional warnings. IMPORTANT: This gun may be used with most common coating and finishing materials. It is designed for use with mildly corrosive and non-abrasive…