DeVilbiss EXL HVLP Gravity Feed

Inside This Document

Part sheet SB-2-202 for the DeVilbiss EXL-620G compliant HVLP gravity feed spray gun — designed to apply a wide variety of finishing materials at maximum transfer efficiency by limiting air cap pressure to 10 psi per SCAQMD and similar air quality rules. The 8 pages cover setup, operation, and service, with HC-4419 and HC-4699 air cap options and the HAV-501 air valve among the listed accessories for compliant gravity-fed spraying.

From the Document

SB-2-202-R1 (4/2018) 1 / 8 www.carlisleft.com IMPORTANT: Before using this equipment, read all safety precautions and instructions. Keep for future use. DESCRIPTION The compliant high volume low pressure gravity feed EXL guns are designed to ap - ply a wide variety of finishing materials. These guns were manufactured to provide a maximum transfer efficiency by limiting air cap pressure to 10 psi (complies with rules issued by SCAQMD and other air quality authorities). These guns will produce approximately 10 psi air cap pressure at 30 psi gun inlet pressure. Air cap test kits are available (see Accessories) which can be utilized to set the exact air cap pressure. Air consumption for the EXL-620G (#2000 cap) is 15.5 SCFM at 10 psi air cap presssure. This gun should not be used with chlorinated solvent materials. Halogenated hydrocarbon solvents (for example: methylene chloride and 1, 1, 1, - Trichloroethane) are not chemically compatible with the aluminum that might be used in many system components. The chemical reaction caused by these solvents reacting with aluminum can become violent and lead to equipment explosion. See page 2 for potential hazards. Important: This gun may be used with most common coating and finishing materials. It is designed for use with mildly corrosive and non-abrasive materials. If used with other high corrosive or abrasive materials, it must be expected that frequent and thor - ough cleaning will be required and the necessity for replacement of parts will be increased. INSTALLATION For maximum transfer efficiency, do not use more pressure than is…