C.A. Technologies Tomahawk

Inside This Document

The setup and parts sheet for the C.A. Technologies Tomahawk spray gun. The conventional air cap and fluid nozzle chart maps the 21-2166/21-2266/21-2366 series caps across the 0.6–1.8 mm fluid tip range with available nozzles from 0.6 mm (31-0606) and 0.7 mm (31-0607) with matching needles, plus fan control and SCFM figures. The 5-page reference for conventional setup and service reorders on the Tomahawk platform.

From the Document

CA Tech Tomahawk Spray Gun Click-n-Pick Spare Parts Cutsheet Easily find spare parts without digging through the full manual. Click on part numbers to order. CONVENTIONAL AIR CAP AND FLUID NOZZLE CHART MODEL NO. PRESS / SIPHON AIR CAP FLUID TIP RANGE FAN CONTROL SCFM AIR CAP RING AVAILABLE FLUID NOZZLES NEEDLES / marking on needle 21-2166 0.6 - 1.8 5 21-2266 0.6 - 1.8 12 31-0606 0.6mm (.022") 21-2266T 0.6 - 1.8 12 31-0607 0.7mm (.028") 21-2366 0.6 - 1.8 12 31-0610 1.0mm (.040") 21-2466 0.6 - 1.8 15 31-0612 1.2mm (.046") 21-2163 0.6 - 1.8 8 31-0613 1.3mm (.052") 21-2263 0.6 - 1.8 14 31-0615 1.5mm (.059") 21-2266-3 0.6 - 1.8 16.2 31-0618 1.8mm (.070") 21-2266-3T 0.6 - 1.8 16.2 Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Gun inlet pressures may vary as required by application TG 60-1317 Included Siphon Pressure 40-2807 (2807) 40-2810 (2810) 40-2815 (2815) T T T T Tomaha omaha omaha omaha omahawk wk wk wk wk PRESSURE/SIPHON FEED SPRAY GUN PRODUCT INFORMATION DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for T T T T Tomaha omaha omaha omaha omahawk wk wk wk wk Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Connect a pressurized fluid supply to the gun fluid inlet. 3. Fluid flow can be controlled using the fluid control knob, this restricts flow by limiting needle travel. It is best to control fluid flow by proper selection of fluid orifice size and use the fluid control knob to “fine tune flow rate”. 4. Fan width…