C.A. Technologies Lynx 300C

Inside This Document

The setup and parts sheet for the C.A. Technologies Lynx 300C — the 300-series conventional Lynx. The chart maps recommended gun inlet pressures and SCFM for pressure and siphon feed to fluid nozzles from 0.8 mm (33-0608) and 1.0 mm (33-0610) with matching 40-13xxC needles, with the 23-2013 cap and CAT Pack contents flagged. The 5-page reference for setup and service reorders on the higher-output conventional Lynx.

From the Document

CONVENTIONAL AIR CAP AND FLUID NOZZLE CHART MODEL NO. AIR CAPS PRESS. OR SIPHON *RECOM. GUN INLET PRESS. FAN CONTROL SCFM @ MAX GUN INLET AIR CAP RING STANDARD IN CAT PACK AVAILABLE FLUID NOZZLES TIPS NEEDLES / marking on needle press/siph Included 33-0608 0.8mm (.022") 40-1308C (308) press/siph 33-0610 1.0mm (.040") 40-1310C (310) 23-2013* press/siph Included 33-0613 1.3mm (.052") 40-1313C (313) 23-2014* press/siph 33-0614 1.4mm (.055") 40-1314C (314) 23-2016* press/siph Included 33-0616 1.6mm (.063") 40-1315C (315) Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Gun inlet pressures may vary as required by application 9-10.7 23-0201 LYNX 300C (L300C) 23-2010* 45-55 60-1500 PRESSURE/SIPHON FEED SPRAY GUN PRODUCT INFORMATION Lynx 300C DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for L300C Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Connect a pressurized fluid supply or paint siphon cup to the gun fluid inlet. 3. Fluid flow can be controlled using the fluid control knob, this restricts flow by limiting needle travel. It is best to control fluid flow by proper selection of fluid orifice size and use the fluid control knob to “fine tune flow rate”. 4. Fan width can be adjusted using the fan control knob. Turning the knob clockwise narrows the fan. Maintenance IMPORTANT! Routine cleaning and maintenance is essential to insure proper gun operation. Several states prohibit spraying solvent into the atmosphere and…