C.A. Technologies Lynx 200H

Inside This Document

The setup and parts sheet for the C.A. Technologies Lynx 200H — the 200-series HVLP Lynx. The chart maps the 22-1028 and 22-1033 pressure caps (29 and 38 PSI maximum inlet for compliance, ~18 SCFM with the 60-1502 #2 fan control) to fluid nozzles from 1.1 mm (32-0611) and 1.4 mm (32-0614) with matching needles. The 4 pages cover compliant setup where bigger tips and higher fluid speeds are needed than the 100-series delivers.

From the Document

HVLP AIR CAP AND FLUID NOZZLE CHART MODEL NO. AIR CAPS Press / Siphon *MAX GUN INLET PRESS. FOR HVLP FAN CONTROL SCFM @ MAX GUN INLET AIR CAP RING AVAILABLE FLUID NOZZLES TIPS NEEDLES / marking on needle 22-1028 pressure 29 60-1502 (#2) 18 32-0611 1.1mm (.042") 40-1211 (211) 22-1033 pressure 38 60-1502 (#2) 18.75 32-0614 1.4mm (.055") 40-1214 (214) 22-1057 pressure 50 60-1502 (#2) 22 32-0618 1.8mm (.070") 40-1218 (218) 22-1100 pressure 37 60-1501 (#1) 18 32-0622 2.2mm (.086") 40-1222 (222) 22-1100 X 2.2S siphon 37 60-1502 (#2) 18 32-0211 1.1mm (.042") 40-1211 (211) 22-1046** pressure 47 60-1502 (#2) 22.5 32-0214 1.4mm (.055") 40-1214 (214) 22-1083** pressure 55 60-1502 (#2) 26 32-0218 1.8mm (.070") 40-1218 (218) 32-0222 2.2mm (.086") 40-1222 (222) *Note: Air cap test gages are available to confirm HVLP compliance. **Must be used with 32-02XX fluid nozzle tips L200H 22-1001 L L L L Lynx 200H ynx 200H ynx 200H ynx 200H ynx 200H PRESSURE FEED SPRAY GUN PRODUCT INFORMATION DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for L200H L200H L200H L200H L200H Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Connect a pressurized fluid supply to the gun fluid inlet. 3. Fluid flow can be controlled using the fluid control knob, this restricts flow by limiting needle travel. It is best to control fluid flow by proper selection of fluid orifice size and use the fluid control knob to “fine tune flow rate”. 4. Fan width can be adjusted using the fan control knob. Turning the knob clockwise…