C.A. Technologies Lynx 200C

Inside This Document

The setup and parts sheet for the C.A. Technologies Lynx 200C — the 200-series conventional Lynx. The chart maps siphon and pressure caps (22-2030, 22-2058, 22-2080, and the pressure-fed 22-2062) with suggested inlet pressures and SCFM to fluid nozzles from 1.1 mm (32-0611) through 1.4 mm (32-0614) and beyond with matching 40-12xx needles. The 4 pages cover setup for general industrial spraying on the 200-series platform.

From the Document

CONVENTIONAL AIR CAP AND FLUID NOZZLE CHART MODEL NO. AIR CAPS Press / Siphon *SUGGESTED GUN INLET PRESS. FAN CONTROL SCFM AIR CAP RING AVAILABLE FLUID NOZZLES NEEDLES / marking on needle 22-2030 siphon 50 12 22-2058 p & s 40 6 32-0611 1.1mm (.042") 40-1211 (211) 22-2080 siphon 60 14 32-0614 1.4mm (.055") 40-1214 (214) 22-2062** pressure 80 19 32-0618 1.8mm (.070") 40-1218 (218) 22-2064** pressure 80 22 32-0618V 1.8mm (.070") 40-5301 22-2704 pressure 70 21 32-0818 1.8mm (.070") 22-2765 pressure 80 22 32-0622 2.2mm (.086") 22-2777 pressure 70 23 32-0622V 2.2mm (.086") 40-5301 22-2797 pressure 70 21 32-0628 2.8mm (.110") 40-1228 (228) 22-2880 siphon 60 15 included 32-0628V 2.8mm (.110") 40-5301 22-2900 siphon 45 12 22-1001 Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Gun inlet pressures may vary as required by application **Air caps available with teflon coating (22-2062T & 22-2064T) 40-1222 (222) L200C 60-1500 included 22-1001 L L L L Lynx 200C ynx 200C ynx 200C ynx 200C ynx 200C PRESSURE/SIPHON FEED SPRAY GUN PRODUCT INFORMATION DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for L200C L200C L200C L200C L200C Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Connect a pressurized fluid supply or paint siphon cup to the gun fluid inlet. 3. Fluid flow can be controlled using the fluid control knob, this restricts flow by limiting needle travel. It is best to control fluid flow by proper selection of fluid orifice…