C.A. Technologies/Manual

C.A. Technologies Jaguar 300H

Jaguar · Jaguar 300H

C.A. Technologies service manual for the Jaguar (models Jaguar 300H). 5-page PDF — view online or download free from CET.

Viewing: C.A. Technologies Jaguar 300H

Open Download

Inside This Document

The setup and parts sheet for the C.A. Technologies Jaguar 300H — the higher-output HVLP Jaguar. The chart maps the 23-1008/23-1010/23-1012 caps at 40 PSI maximum gun inlet pressure and 13.5 SCFM to fluid nozzles from 0.8 mm (33-0208) with matching 40-13xx needles. The 5-page reference for compliant HVLP setup where the 100-series' 15 PSI ceiling doesn't deliver enough fluid speed for the material.

From the Document

HVLP AIR CAP AND FLUID NOZZLE CHART MODEL NO. AIR CAPS *MAX GUN INLET PRESS. FOR HVLP FAN CONTROL SCFM @ MAX GUN INLET AIR CAP RING AVAILABLE FLUID NOZZLES TIPS NEEDLES / marking on needle 23-1008 40** 13.5 33-0208 0.8mm (.022") 40-1308 (308) 23-1010 40** 13.5 33-0210 1.0mm (.040") 40-1310 (310) 23-1012 40** 13.5 33-0212 1.2mm (.046") 40-1312 (312) 23-1013 40** 13.5 33-0213 1.3mm (.052") 40-1313 (313) 23-1014 40** 13.5 33-0214 1.4mm (.055") 40-1314 (314) 23-1015 40** 13.5 33-0215 1.5mm (.059") 40-1315 (315) 23-1017 40** 13.5 33-0217 1.7mm (.070") 40-1317 (317) 23-1019 40** 13.5 33-0219 1.9mm (.075") 40-1319 (319) 23-1022 40** 13.5 33-0222 2.2mm (.086") 40-1322 (322) Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Note: Air cap test gages are available to confirm HVLP compliance. *Gun inlet pressures may vary as required by application **When using optional gun regulator, inlet pressure changes to 45psi Included J300H 60-1502 (#2) GRAVITY FEED SPRAY GUN PRODUCT INFORMATION Jaguar 300H Jaguar 300H Jaguar 300H Jaguar 300H Jaguar 300H DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for J300H J300H J300H J300H J300H Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Screw the paint cup onto the gun’s gravity feed fluid inlet. 3. Fluid flow can be controlled using the fluid control knob, this restricts flow by limiting needle travel. It is best to control fluid flow by proper selection of fluid orifice size and use the fluid…