C.A. Technologies Jaguar 100CVT

Inside This Document

The setup and parts sheet for the C.A. Technologies Jaguar 100CVT — the conventional Jaguar configured for heavy-bodied materials, with fluid nozzles from 1.8 mm (31-0618) up through 2.2 mm (31-0622) and beyond, including V-series nozzle variants with their 40-6201 needle. Sideport control and approximate CFM figures complete the chart. The 4 pages cover the big-tip combinations for adhesives, texture, and high-viscosity coatings on the Jaguar platform.

From the Document

JAGUAR 100CVT CONVENTIONAL AIR CAP AND FLUID NOZZLE CHART MODEL NO. AIR CAPS FLUID TIP RANGE SIDEPORT CONTROL APPROXIMATE CFM AIR CAP RING AVAILABLE FLUID NOZZLES TIPS NEEDLES / marking on needle 31-0618 1.8mm (.070") 40-1115 (115) 31-0618V 1.8mm (.070") 40-6201 31-0622 2.2mm (.086") 40-1122 (122) 31-0622V 2.2mm (.086") 40-6201 31-0628 2.8mm (.110") 40-1128 (128) 31-0628V 2.8mm (.110") 40-6201 Actual fluid nozzle and air cap combinations are determined by application Fluid nozzles ending in "V" are carbide fluid tips Included 2.8 2.2 1.8 15 15 15 J100CVT 60-1500 21-2466 21-2467 21-2268 GRAVITY FEED SPRAY GUN PRODUCT INFORMATION Jaguar 1 Jaguar 1 Jaguar 1 Jaguar 1 Jaguar 100CV 00CV 00CV 00CV 00CVT T T T T DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for J100CVT J100CVT J100CVT J100CVT J100CVT Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Screw the paint cup onto the gun’s gravity feed fluid inlet. 3. Fluid flow can be controlled using the fluid control knob, this restricts flow by limiting needle travel. It is best to control fluid flow by proper selection of fluid orifice size and use the fluid control knob to “fine tune flow rate”. 4. Fan width can be adjusted using the fan control knob. Turning the knob clockwise narrows the fan. Maintenance IMPORTANT! Routine cleaning and maintenance is essential to insure proper gun operation. Several states prohibit spraying solvent into the atmosphere and require the use of covered gun cleaner. 1. If a gun cleaner is being used,…