C.A. Technologies FE-Line LCFM

Inside This Document

The setup and parts sheet for the C.A. Technologies FE-Line LCFM — the low-CFM version of the fine finish platform for shops with limited compressor capacity. The HVLP chart maps the 21-1090/21-1091 caps at 15 PSI maximum inlet pressure and just 6–8 SCFM to fluid nozzles from 0.5 mm (31-0205) upward, pairing compliance with minimal air demand. The 4 pages cover the combinations that deliver fine finishes on small air systems.

From the Document

HVLP AIR CAP AND FLUID NOZZLE CHART MODEL NO. AIR CAPS Press / Siphon *MAX GUN INLET PRESS. FOR HVLP FAN CONTROL SCFM @ MAX GUN INLET AIR CAP RING STANDARD IN CAT PACK AVAILABLE FLUID NOZZLES TIPS NEEDLES / marking on needle 31-0205 0.5mm (.020") Included 31-0208 0.8mm (.022") 21-1090 pressure 15 6 31-0210 1.0mm (.040") 21-1091 pressure 15 8 31-0212 1.2mm (.046") 21-1092 pressure 15 8 Included 31-0213 1.3mm (.052") 21-1093 pressure 18 10 31-0214 1.4mm (.055") 21-1094 pressure 33 13 31-0215 1.5mm (.059") 31-0216 1.6mm (.063") Included 31-0217 1.7mm (.070") *Note: Air cap test gages are available to confirm HVLP compliance. Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Gun inlet pressures may vary as required by application 40-1801 (1801) FE-LINE LOW CFM (FELCFM) 60-1317 21-1001 FE-Line LCFM PRESSURE FEED SPRAY GUN PRODUCT INFORMATION DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for FE-LCFM Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Connect a pressurized fluid supply to the gun fluid inlet. 3. Fluid flow can be controlled using the fluid control knob, this restricts flow by limiting needle travel. It is best to control fluid flow by proper selection of fluid orifice size and use the fluid control knob to “fine tune flow rate”. 4. Fan width can be adjusted using the fan control knob. Turning the knob clockwise narrows the fan. Maintenance IMPORTANT! Routine cleaning and maintenance is essential to insure…