C.A. Technologies CAT Xpress

Inside This Document

The setup and parts sheet for the C.A. Technologies CAT-Xpress pressure feed spray gun, which offers both a pressure-reduced air cap (2403218/2403224) and an HVLP air cap (2403233/2403235) for compliance areas — each consuming 9 CFM at its rated inlet pressure. The nozzle chart pairs fluid tips from 0.8 mm to 2.2 mm with matching needles by part number, covering fine finish through heavier coatings.

From the Document

1 HVLP/Pressure reduced air cap and fluid nozzle chart Pressure reduced air cap SCFM @ max gun inlet pressure HVLP air cap SCFM @ max gun inlet pressure for HVLP Fluid tip range Orifice size Fluid tip part number Fluid needle part number 2403218 9 CFM @ 29 PSI 2403233 9 CFM @ 26 PSI 0.8 mm to 1.8 mm 0.8 mm 2404488 2397054 1.0 mm 2404489 2397055 1.2 mm 2404491 2397056 1.3 mm 2412850 2412848 1.4 mm 2397074 2397057 1.5 mm 2404492 2397058 1.8 mm 2404493 2397059 2403224 9 CFM @ 29 PSI 2403235 9 CFM @ 26 PSI 2.0 mm 2.2 mm 2.0 mm 2404494 2397060 2.2 mm 2404495 2397061 Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Gun inlet pressures may vary as required by application *Smaller and larger nozzle sizes are available upon request CAT-Xpress PRESSURE FEED SPRAY GUN PRODUCT INFORMATION The CAT-Xpress spray gun offers both a pressure reduced air cap (2403218 &2403224) and HVLP air cap (2403233 & 2403235) for areas requiring HVLP compliance. 2403218 & 2403224 - Consumes 9 cfm at 29 psi gun inlet - Pressure reduced - 2403218 - can be used with 0.8 mm - 1.8 mm orifices - 2403244 - can be used with 2.0 mm - 2.2 mm orifices 2403233 & 2403235 - Consumes 9 cfm at 26 psi gun inlet - For areas requiring HVLP compliance. - 2403233 - can be used with 0.8 mm - 1.8 mm orifices - 2403235 - can be used with 2.0 mm - 2.2 mm orifices BLUE = CLICK TO ORDER 2 Operation and Maintenance Instructions for CAT-Xpress Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Connect a pressurized fluid supply to the gun fluid inlet. 3.…